Low-built lift table

The hydraulic unit has a transparent oil tank for easy checking of the oil level. Furthermore, like all electrical components, the power pack has protection class IP65. The entire unit is protected against splashing and dripping water and runs particularly quietly thanks to the suction and return flow filters in the tank. The overflow valve on the oil tank completes the successful hydraulic unit. Depending on the lift table or requirements, the power unit is located either inside or outside the lift table.

The torsion-resistant shears are made of rectangular profiles, which in contrast to flat steel profiles ensures greater lateral stability. In particular, the transverse loads on the bearings are minimized, which is beneficial to the service life of the bearings.

The automated production and processing of the components guarantee a reproducible production quality, which in turn enables a particularly high movement accuracy and an almost jerk-free lifting process. The extremely clean processing provides a perfect basis for the two-component paint, which guarantees a high level of corrosion protection.

The stable aluminium contact protection strip underneath the lift table platform minimises the risk of injury. As soon as it is lifted by e.g. an arm, hand, foot or an object, the limit switches located underneath the platform trigger the emergency stop function. Further lowering of the platform is thus prevented.

The robust industrial motor, which is attached to the front of the hydraulic unit, naturally has protection class IP55. A thermal protection protects the motor from overheating and thus from damage in case of overload.

The lifting cylinders of our lifting tables are always equipped with a pipe rupture safety valve, which prevents lowering through a defective or leaking pipe. The hydraulic cylinders, which are equipped with end position damping, ensure a jerk-free approach to the end positions.

The wide fork rollers, which run in the base frame, guarantee perfect load compensation and prevent transverse loads due to their design. The anodised surface and the lateral grease nipples considerably simplify maintenance and increase the service life of the lift table.

Adjustable lift limit switches allow the end height to be varied and thus to be adjusted once to the spatial conditions during on-site installation. The setting can also be adjusted subsequently by loosening a screw and adjusting the limit switch manually.

The maintenance supports prescribed in the safety requirement according to DIN EN 1570-1 are folded down at the beginning of the maintenance and service work. They provide purely mechanical protection against unintentional lowering of the lift table platform. This ensures safe working under the platform or in the area of the scissors.

The lowering valve, which is adjustable with a screw, ensures a constant lowering speed, independent of the load.

The lift table is equipped with wide bearing designs so that the load on the bearing points is reduced to a minimum. The anodized axles and bearing sleeves can be changed quickly and the grease nipples also simplify maintenance considerably.

The type plate contains the machine number and the CE marking. This indicates that a product complies with EC requirements imposed on the manufacturer. You can therefore be sure that the lift table has been manufactured in accordance with the applicable Community regulations and the corresponding conformity assessment procedures.